ACS Applied Materials & Interfaces is a peer-reviewed scientific journal that was established in 2009 by the American Chemical Society. The current editor in chief is Kirk S. Schanze. ACS Applied Materials & Interfaces covers advanced active and passive electronic/optical materials, coatings, colloids, biomaterials and bio-interfaces, polymer materials, hybrid and composite materials; and friction and wear. It is currently indexed/abstracted in: CAS, MEDLINE/PubMed, Current Contents, and Science Citation Index.
Electronics & Semiconductors
The glittering, serpentine structures that power wearable electronics can be created with the same technology used to print rock concert t-shirts, new research shows.
Jan 12, 2023
0
93
Engineering
Stealth fighters and bombers are among the most expensive aircraft in the world, and they rely on a radar-absorbent polymer skin to avoid detection. But that polymer is so fragile that these high-end aircraft have to be designed ...
May 18, 2021
1
17
Engineering
A new North Carolina State University study, performed in collaboration with battery testing researchers at the U.S. Department of Energy's Oak Ridge National Laboratory, shows that extremely short pulses from a high-powered ...
Feb 8, 2023
0
158
Electronics & Semiconductors
Benoît Lessard and his team are developing carbon-based technologies which could lead to improved flexible phone displays, make robotic skin more sensitive and allow for wearable electronics that could monitor the physical ...
Jan 27, 2021
1
42
Engineering
LED lightbulbs offer considerable advantages over other types of lighting. Being more efficient, they require much less electricity to operate. They do not give off unwanted heat the way old-school incandescent bulbs do, ...
May 25, 2021
0
6
Engineering
Safety issues of self-driving cars have emerged due to frequent traffic accidents. A self-healing lens material that can prevent car accidents that occur due to signal distortion by healing scratches on the sensor surface ...
May 22, 2023
0
89
Energy & Green Tech
The variety of humble algae that cover the surface of ponds and seas could hold the key to boosting the efficiency of artificial photosynthesis, allowing scientists to produce more energy and lower waste in the process.
Oct 18, 2021
0
511
Engineering
Three-dimensional (3D) metal–plastic composite structures have widespread potential applicability in smart electronics, micro/nanosensing, internet-of-things (IoT) devices, and even quantum computing. Devices constructed ...
Nov 30, 2022
0
35
Engineering
The DGIST Thin Film Solar Cell Research Center worked with Professor Kim Se-yoon of the Department of New Material Engineering at Kyungnam University to investigate the cause of pore formation, a problem in CZTS thin-film ...
Aug 12, 2022
0
89
Engineering
A research team led by Professor Kyung-In Jang at the Department of Robotics and Mechanical and Electronic Engineering, DGIST, and another led by Professor Jihwan Choi at the Department of Aerospace Engineering, KAIST, developed ...
Dec 27, 2023
0
6
