A colossal step for electronics: New method creates major increase in electrical resistance

A colossal step for electronics
Fig.1 Strongly Correlated Oxide Proton Resistor devices. Credit: Osaka University

Researchers at Osaka University demonstrated a new technique for modifying the hydrogen concentration of resistors by applying an electrical voltage. The generated electric field drove the diffusion of hydrogen ions deeper into the perovskite rare-earth nickelate lattice, which led to a tunable "colossal" increase in electrical resistance. This research can lead to new gas sensors and electrically switchable smart materials.

Computer chips depend on the careful control of electrical signals through semiconductors. Conventionally, the conductivity of silicon chips is modified by intentionally "doping" them with impurity ions. However, this process is usually done once at the factory, and cannot be changed later. Thus, the ability to dynamically control the doping of materials would open the way for novel switches and potentially even entirely new kinds of computer circuits.

Now, scientists at Osaka University have created thin films of neodymium nickel oxide (NdNiO3) with an that can change dramatically by controlling the distribution of ions (protons) in the film. The hydrogen was added in a process called "gas-phase annealing" in which the thin film, which has a , was exposed to hydrogen gas in the presence of an which caused the formation of hydrogen protons. This reaction was sped up by platinum electrodes, which act as catalysts.

Increasing the annealing temperature caused more protons to diffuse into the film. At , the resistance of the films doubled from the original value, but jumped by a factor of 30 at 200°C. "We call such a large increase in resistance 'colossal' because it is easily detected in ," first author Umar Sidik explains.

A colossal step for electronics
Fig.2 Schematic illustrations of Proton Resistor devices and their electric bias-dependent resistance modulation ratio. Credit: Osaka University

In this way, the combination of electric field and gas-phase annealing at a desired temperature was shown to enable control of the diffusional doping, which led to electrically tunable colossal resistive devices. The crystal structures were confirmed using X-ray diffraction and optical microscopy. The change was visible because the hydrogen-doped region became optically transparent.

"In addition to the large resistance modulation, ion doping also has potential to reversibly change the structural and electronic properties of correlated materials via an electric field by manipulating the ion diffusion process into or out of a material," senior author Azusa N. Hattori says. In fact, this can lead to the whole area of "iontronic" devices that rely on ion motion within a solid lattice to function.

Explore further

A novel recipe for efficiently removing intrinsic defects from hard crystals

More information: Umar Sidik et al. Catalytic Hydrogen Doping of NdNiO3 Thin Films under Electric Fields, ACS Applied Materials & Interfaces (2020). DOI: 10.1021/acsami.0c15724
Provided by Osaka University
Citation: A colossal step for electronics: New method creates major increase in electrical resistance (2020, December 9) retrieved 11 April 2021 from https://techxplore.com/news/2020-12-colossal-electronics-method-major-electrical.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Feedback to editors

User comments