This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:

fact-checked

peer-reviewed publication

trusted source

proofread

Lithium-ion batteries from drones might find second lives in less 'stressful' devices

Lithium-ion batteries from drones might find second lives in less 'stressful' devices
High power requirements in eVTOL load profiles and electrochemical behavior of lithium-ion batteries under simulated takeoff step. (A) Schematic diagram showing major segments of an eVTOL mission profile and the corresponding power requirements. We are interested in evaluating the behavior of lithium-ion batteries within the initial high-power segment of takeoff. (B) Current profile for the testing carried out in this study. Cells are charged at a nominal 1C rate until a full state-of-charge is achieved (4.2 V cutoff). At the beginning of discharge, a current pulse equivalent to 15C is applied for 45 s. Subsequent discharge is carried out at a nominal C/3 current. For the batteries investigated here, 1C corresponds to ∼0.08 A, and 15C corresponds to roughly 1.2 A. (C) First charge–discharge cycle polarization curve with the dotted line showing the charge cycle and solid line depicting the discharge cycle. (D) Capacity retention of the cell over extended cycling under the simulated climb step discharge protocol. (E) Complete polarization curves and (F) zoomed in plot of the polarizations within the 15C discharge pulse segment for the 1st, 25th, 50th, 75th, and 100th cycles. The cut-off voltage of 3 V is identified by a dashed line in (E) and (F). Credit: ACS Energy Letters (2024). DOI: 10.1021/acsenergylett.3c02385

Taking flight can be stressful—especially for a lithium-ion battery that powers a drone. Too much strain on these cells causes damage and shortens a device's overall lifespan. Research in ACS Energy Letters shows the potential to improve batteries in aerial electric vehicles that take off and land vertically. The team developed a new electrolyte to address these challenges and said the "stressed out" batteries could also have second lives in less strenuous applications.

Lithium-ion batteries (LiBs) have exploded in popularity thanks to their ability to pack a large amount of in a relatively small and light package. But they aren't perfect, especially when a lot of that power needs to be drawn from the in a short amount of time.

For example, drones put a high strain on their batteries during takeoff. While hobby drones traditionally use lithium-ion polymer batteries instead of LiBs, the latter's is better suited for heavier-duty drones, such as those that deliver cargo to remote locations. To better understand how high-strain events like liftoff can affect LiB stability, Ilias Belharouak, Marm Dixit, and colleagues "stressed out" a set of LiBs and investigated how their performance changed.

The researchers manufactured a set of LiB cells containing a specially designed, fast-charging, and discharging electrolyte. Then, they drained 15 times the battery's optimal capacity, the total amount of energy it could store, for 45 seconds. This process simulated the rapid, high-power draw, also known as a discharge, needed during vertical takeoff.

After the initial discharge pulse, the cells were further drained at a more normal discharge rate and then recharged. The team found that none of the tested cells lasted more than 100 cycles under these high-stress conditions, with most starting to show decreased performance around 85 cycles.

After being "stressed," the researchers subjected the LiB cells to a more normal, lower-rate power draw. In this experiment, they observed that the cells partially retained their capacities under low-rate conditions but failed quickly when put under rapid current drain conditions again.

These results indicate that the LiBs typically used in drones might not have the characteristics necessary for long-term, high-stress usages, but they could be retired and meet more typical power demands in other applications, such as battery back-ups for power supplies and energy-grid storage. The researchers say that more work is needed to develop alternative battery technologies that are better suited for vertical takeoff and other high-power-demand applications.

More information: Marm Dixit et al, Lithium-Ion Battery Power Performance Assessment for the Climb Step of an Electric Vertical Takeoff and Landing (eVTOL) Application, ACS Energy Letters (2024). DOI: 10.1021/acsenergylett.3c02385

Journal information: ACS Energy Letters
Citation: Lithium-ion batteries from drones might find second lives in less 'stressful' devices (2024, March 1) retrieved 18 April 2024 from https://techxplore.com/news/2024-03-lithium-ion-batteries-drones-stressful.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

Customizing sulfone electrolyte in lithium-ion batteries improves their safety and performance

39 shares

Feedback to editors