This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:

fact-checked

reputable news agency

proofread

GM's Cruise to start testing robotaxis in Phoenix area with human safety drivers on board

GM's Cruise to start testing robotaxis in Phoenix area with human safety drivers on board
Cruise AV, General Motor's autonomous electric Bolt EV, is seen on Jan. 16, 2019, in Detroit. General Motors' troubled Cruise autonomous vehicle unit said Monday, May 13, 2024, that it will start testing robotaxis in Arizona this week with human safety drivers on board. Credit: AP Photo/Paul Sancya, File

General Motors' troubled Cruise autonomous vehicle unit said Monday it will start testing robotaxis in Arizona this week with human safety drivers on board.

Cruise said that during the testing, it will check the vehicles' performance against the company's "rigorous" safety and autonomous vehicle performance requirements.

Testing will start in Phoenix and gradually expand to Scottsdale, Tempe, Mesa, Gilbert, Chandler and Paradise Valley, the company said. The vehicles will operate in autonomous mode, but the human drivers will be ready to take over if needed as the company takes a step toward resuming driverless operations.

Human drivers are important in testing the vehicles' performance "and the continuous improvement of our technology," Cruise said.

Cruise suspended operations in October when one of its Chevrolet Bolt autonomous electric vehicles dragged a San Francisco pedestrian roughly 20 feet (6 meters) to the curb at roughly 7 miles per hour (11 kilometers per hour), after the pedestrian was hit by a human-driven vehicle.

But the California Public Utilities Commission, which in August granted Cruise a permit to operate an around-the-clock fleet of computer-driven taxis throughout San Francisco, alleged Cruise then covered up details of the crash for more than two weeks.

The incident resulted in Cruise's license to operate its driverless fleet in California being suspended by regulators and triggered a purge of its leadership—in addition to layoffs that jettisoned about a quarter of its workforce—as GM curtailed its once-lofty ambitions in self-driving technology.

A new management team that General Motors installed at Cruise following the October incident acknowledged the company didn't fully inform regulators.

Phil Koopman, a professor at Carnegie Mellon University who studies autonomous vehicle safety, said Phoenix is a good choice for Cruise to restart its operations, in part because it has less stringent regulations than the company faced in San Francisco.

The Phoenix area also has broad streets instead of narrow ones like San Francisco, and it has less traffic and fewer emergency vehicles, which caused problems for Cruise in San Francisco, he said.

"Good for them for being conservative," Koopman said. "I think that in their position, it's a smart move."

© 2024 The Associated Press. All rights reserved. This material may not be published, broadcast, rewritten or redistributed without permission.

Citation: GM's Cruise to start testing robotaxis in Phoenix area with human safety drivers on board (2024, May 13) retrieved 15 June 2024 from https://techxplore.com/news/2024-05-gm-cruise-robotaxis-phoenix-area.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

GM says Cruise robotaxis back on the road with human drivers

1 shares

Feedback to editors